Konig Electronic Wireless microphone system 16 channel - Manual (Page 3)

3
ENGLISH
Description LCD display receiver
• RF: Shows the strength of the received microphone signal
• AF: Shows the microphone’s audio signal level
• CH01: Selected pre-programmed channel
• A ANT: The antenna which receives the signal of the microphone (A for receiver A and B
for receiver B)
• 864.40: Frequency of the selected pre-programmed channel
• OPEN: Shows which receiver (display) is selected for the use of function buttons 2–5
• AUTO: Shows that the microphone is powered off. Appears also when there is no
connection with the microphone on the showed frequency in the display
• MUTE: There is no audio output from the receiver to mixer or amplifier because the
microphone is powered off or there is no reception
• TUNE: Push the SELECT button (2) to switch between manual tuning or pre-programmed
channels. With manual tuning it’s possible to select the frequency by steps of
0.05 MHz. The range is 840.00 MHz till 868.00 MHz. This feature offers the use of
other wireless microphones operating in the frequency band from 840.00 MHz
till 868.00 MHz. Note: the supplied microphones are pre-programmed from
863.00 MHz till 865.00 MHz
IMPORTANT NOTICE: It’s the responsibility of the user to ensure that the use of frequencies
comply with the local regulations and does not cause interference with other users.