Krix Epix - Manual (Page 9)

installation
9
routing speaker cable
6. Route speaker cable through studwork to speaker.
7. Securely screw cable into to binding posts. Take care to assign the same
cable colour or trace to the positive (+) connector on the amplifier, as the
positive (+) connector on the speaker. Repeat connection process with
negative (-) binding post and negative (-) wire.
Single Pair
When using single pair cable,
LF- and HF- must be bridge
and LF+ and HF+ must be
bridged.
Note if bridging connections
are not made, the speaker
will not produce both bass
and treble. !
Bi-WIre
When Bi-wiring the Epix
connect LF and HF cables to the
corresponding binding posts.
AMP
HF+
L F-
HF-
L F+
HF LF
HF+
L F-
HF-
L F+