Lab.gruppen IPD 2400 - Manual (Page 24)

11. Updating amplifier firmware
24
IPD SERIES Operation Manual rev 1.0.0
11. Updating amplifier firmware
There are three ways to update firmware on IPD units; each method serves different purpose.
1. Global View/Tools/”Firmware Update All units”.
This updater allows simultaneous update of all IPDs connected to the network and has built in mechanisms
that scan the version number of the units so that only those units with old firmware are updated. It also verifies
the process, repeats updating if some should fail, and summarizes the process once completed. This process
takes a couple of minutes but is the safest way to update the IPD units.
2. Global View/Tools/”Enable Update”.
This updater displays a symbol in Global view which makes it easy to see if any unit is not up to date. A symbol
appearing on the Amplifier Control Panel is gray if firmware is up to date and orange if firmware is not up to
date. If not up to date (orange) you can click the symbol to start the update. “Enable Update” also works as a
recovery tool. If the firmware update somehow gets interrupted, e.g. through power loss in the middle of
updating, the unit can end up in fault state. The Enable Update tool can, in most circumstances, reach the
faulty unit and re-update the Firmware, bringing it back to normal.
3. From within the Mixer (Unit) View, click hardware/firmware update.
This update is for a single unit only and will force new firmware to the unit regardless of what firmware the IPD
currently has. Using this tool, all presets are asked to be backed up and are automatically restored back to the
unit once updated.
Important: A firmware update will erase all presets on the device. Before initiating a firmware update, be sure all
device presets have been backed up using Backup Presets in the Hardware menu. After firmware update has
been completed, restore presets using Restore Presets in the Hardware menu.
12. Operation with iPad App
The iPad App version of IntelliDrive Controller duplicates nearly all of the functions of the Windows version. Also,
appearance of the user interface closely resembles that of the Windows version. However, because of significant
differences in the basic operating system, some differences apply, particularly regarding use of menu commands.
Note: Only one device running IntelliDrive Controller is allowed to access the network at any given time. If you wish
to use an iPad as the controller, you must first close the application on any Windows or Mac computer.