Labconco Purifie Horizontal Clean Benches 32000 Series - Manual (Page 17)

Chapter 3: Getting Started
Product Service 1-800-522-7658 13
Securing the Purifier XT Clean Bench
BEFORE USING THE CLEAN BENCH, IT MUST BE
PROPERLY SECURED TO A WALL OR STRUCTURAL
BEAM TO AVOID TIPPING OVER.
Obtain the following items from the box located on the Purifier XT Clean Bench
worksurface:
(1) Wall-Mount Bracket p/n 3894400
(2) Lashing Strap p/n 3952900
Follow the steps below to secure the clean bench to a wall or other significant
vertical structural building element.
To secure the clean bench:
1. Using proper screws, secure the Wall-Mount Bracket to the wall behind the
final position of the clean bench. Center bracket behind clean bench final
position, with the bracket approximately 68” (1700mm) off the floor. See
Figure 3-3 below.
2. Run the Lashing Strap through the slot in the Wall-Mount Bracket, then
through one of the slots on the back of the clean bench. Run the Lashing
Strap through the other slot on the back of the clean bench. Run the Lashing
Strap through the ratchet mechanism on the strap. See Figure 3-4 below.
3. Push the clean bench against the wall and cinch the Lashing Strap down.
Strap does not have to be tight, but slack should be minimal.
)
Figure 3-3
Wall-Mount
Bracket
Wall
Secure
through both
holes to wall