LG Motorsports LG C6 G2 Coil Overs - Manual (Page 7)

INSTALLATION:
Starting at the front of the car we will first start by installing the upper shock
mount. There should be a nut and washer already started on this when you receive your
package. Remove the nut and washer. Insert the threaded part of the mount through the
hole in the frame that we removed the factory shock from. Place the washer on the top
side of the frame and start the nut. Do this on both sides, leave loose for the moment as
we install the coil over. You can also do this with the mount on the shock, but some do
find it easier to remove this, and install separately.
Figures 10a and 10b: Installation of front coil over
Once the upper portion of the shock is mounted we can now lift the lower control
arm up to insert the supplied bolts.
Figure 11a and 11b: Install of lower shock mount and ball joint
The flat side of the mount should be placed against the lower control arm. One
washer will be between the head of the bolt and the lower control arm, and the other will
be between the nut and the mount. The bolts will insert from the bottom going up. This
is best done with either a helper or a floor jack to raise the control arm assembly. Once
the passenger side is finished, we can re-assemble the lower control arm at the upright on
the driver side at the taper so that we can install the coil over just as we did on the other
side.