Lodar 1 Function FET Receiver and Standard Transmitter - Manual (Page 2)

PRESS
&
HOLD
for
10 SECONDS
at RX
POWER UP
FM Series - Effective working range up to a distance of 60 metres (200 feet).
Narrow Band FM Series - Effective working range up to a distance of 300 metres (1000 feet)
FCC ID: M2H LODAR 8522
This devise complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions, (1) This devise may not cause
harmful interference and, (2) this devise must
accept any interference received, including
interference that may cause undesired
operation.
Serial No. Model No.
92104TX 200000
e 11 023087
www.lodar.com
Battery
Compartment
Release Catch
Button switches off the STOP
Receiver and the keypad function
buttons
switches F2 OFF (de-latch F2)
L.E.D.
Blinks when Transmitter
and Receiver are active.
ON when a Transmitter
Button is pressed.
Pulses while transmitting
when battery is low.
The Transmitter automatically
transmits a
signal after STOP
30 minutes; this de-activates
the Receiver and the Transmitter
keypad.
! SAFETY FEATURE
RESET Button activates
the Receiver and the
keypad function buttons
When pressed switches
F1 ON and latches F2 ON
When released switches
F1 OFF ONLY
(F2 remains ON)
Lo-Cover not shown
LED marked “5V”
Indicates power
supply for control
circuits is OK
LED’s marked
“F1 - F2 “
When ON indicate an
output to that function
LED marked “FAULT”
Indicates an overload is
present; the System
cannot be RESET until
overload is removed.
This LED blinks for 20
seconds when the
Receiver is initially
powered. A replacement
Transmitter has to be
registered during this 20
second period.
LED marked “SET”
Indicates system
is active
VOLTAGE
Working Range
12 Volts to 36 Volts DC
Limits
8 Volts minimum to
40 Volts absolute max.
Note 42 Volt System
48 Volt Max is currently
Special Order
Component Detail
To register Transmitters to the Receiver.
Switch OFF or DISCONNECT the power to the Receiver and briefly PRESS the STOP button
on one or both Transmitter(s). Switch ON or Reconnect the power to the Receiver.
This opens a 20 second registration window in the Receiver processor.
If you are looking at the Receiver PCB the Fault LED Flashes. Immediately PRESS and
HOLD the Transmitter RESET Button for a MINIMUM of 5 seconds during this 20 second
window. When the Transmitter is Registered the Fault LED will be illuminated for 3 seconds.
Within this
period, release the RESET button. 3 second
TO REGISTER TWO TRANSMITTERS:
When the fault light starts to flash again, immediately PRESS and HOLD the Transmitter RESET
Button of the second Transmitter until the SET LED comes on. Both your Transmitters will now operate
the Receiver.
PRIORITY.
Only one Transmitter can be active at any time. For the second Transmitter to work you have to turn off the first Transmitter.
Once the second Transmitter is being used then that has priority and it has to be turned off before the first Transmitter can work
again.
If you have any problems please phone either your local Distributor or Lodar directly:-
UK +44 1922 613633. US 1-877- 257-1581.
92101.02E