Lumagen VisionDVI & VisionHDP - Manual (Page 40)

VisionHDP ™
User Manual and Installer Guide
© 2004-2007 Lumagen®, Inc. 37 Rev 1.14
Specifications
Inputs
• Eight standard inputs: Two composite, two SVideo, two SD/HD component/RGB and two
DVI-D/HDCP inputs.
• Two optional SDI inputs.
• Composite, SVideo and component inputs support NTSC (M, Japan, 4.43), PAL (B, D, G,
H, I, M, N, Nc) and SECAM (B, D, G, K, K1, L).
• Component input color-space can be selected as SDTV or HDTV.
• Absolute maximum rating is ±2 volts, referenced to case ground, for analog video inputs.
Processing
• Per-pixel motion adaptive deinterlacing and inverse-telecine for SD and HD sources.
• Proprietary scaling algorithms provide detail-enhancement.
• Adjustments for sizing, black-level, contrast, color, Hue, color/Hue offset, and Y/C delay.
• 11-point parametric grayscale and gamma calibration.
• Source aspect ratio selection of 4:3, 4:3 nonlinear-stretch, letterbox, 16:9 and 1.85.
• Supports two zoom steps for each source aspect ratio.
• Four independent configuration memories per input.
Output
• DVI-D/HDCP and analog output resolution from 480p to 1080p (VisionHDP), or to 800p
(VisionDVI), at up to 60 Hertz.
• The analog output supports RGB and YP
R
P
B
. Both formats support bilevel and trilevel
sync. RGB also supports discrete horizontal and vertical, or discrete composite, sync with
programmable polarities.
• YP
R
P
B
output color-space can be selected as SDTV or HDTV.
• For red, green, blue and Luma, the nominal output is 1.0 volts peak-to-peak with
embedded sync, and 0.7 volts otherwise. For P
R
and P
B
, the peak-to-peak is 0.7 volts,
including sync. Output levels are specified driving an external 75-ohm load.
• Discrete sync outputs drive TTL levels into an external 75 ohm load.
• Eight independent output configuration memories are supported.
• Resolution is programmable from 480p to 1080p in scanline increments, plus 1080i.
• Vertical refresh rate is programmable from 48 to 120 Hertz in steps of 0.01 Hertz. This
varies with resolution.
• Output aspect ratio is programmable from 1.33 to 2.35 in steps of 0.01.
•
Output size and position are programmable in pixel increments .
Miscellaneous
• Menu based setup.
• Infrared remote or RS232 serial control interface.
• Dimensions: 12” (W) by 5” (D) by 3.5” (H).
• Power consumption: 25 watts nominal.
• The power supply input rating is from 100 to 240 volts at 47 to 63 Hertz.
• Silent operation (no fan).