User manual and installer guide, Visionpro hdp – Lumagen VisionProHDP User Manual
Page 32
VisionPro HDP
™
User Manual and Installer Guide
© 2004-2006 Lumagen®, Inc.
29
Rev 1.1
MENU
→
OUT
→
RES
→
VRES
Vertical active resolution
VRATE
Vertical refresh rate
HRATE
For analog output only: Horizontal rate (normally not used)
HRES
For digital output only: Horizontal active resolution
TIMING
Set output timing parameters in pixel increments
SIZE
Set output size
POS
Output position
ASPECT
Output aspect ratio (1.33 to 2.35 in hundredths)
MISC
→
GBAR
→
SIDE
Side gray-bar intensity (0 to 49 ire)
LBOX
Top/bottom letter-box-bar intensity (Service mode only)
LEVL
→
PDSTL
Analog output black pedestal (0 IRE or 7.5 IRE)
DVILVL
DVI-D output level (VIDEO or PC)
SYNC
→
DVI
Select DVI output sync polarity (use direct command for analog out)
MODE
→
Single (default) or multiple-output-timing mode
SAME
Single output configuration. All memories share output timing
,
etc.
INDEP
Eight independent output configurations.
AUTOIND
Automatically select output configuration for NTSC or PAL input.
COPY
Copy current output configuration to selected output configuration(s)
MENU
→
MISC
→
LCD
→
Visible for VisionPro HDP only
BKLGHT
LCD backlight enable
CNTRST
LCD contrast
OSD
Toggle OSD-enable. Shows status when input selected if enabled
LOCK
Lock or unlock the configuration
POWR
→
AUTO
Unit can go to either “ON” or “STBY” when power is applied
MSG
Change power-on on-screen message by following instructions
RS232
→
Transmit message out RS232 serial port on power on or off
PWRON
Power-on RS232 serial output message
PWROFF
Power-off RS232 serial output message
BAUD
Power on/off message BAUD rate
PAR
Power on/off message parity
GAP
Power on/off message character spacing
TPAT
Test and warm-up patterns
PATS
Test patterns
WARMUP
Warm-up patterns
MENU
→
SAVE
→
Note: Unsaved changes can be discarded by going to STBY
SAVE
Save current configuration to flash ROM.
UNDO
Toggle between current saved and previous saved configurations
RESTORE
Restore from calibrator’s hidden configuration
FCTRY
Reset to factory defaults