Luxul XWR-1750 - Manual (Page 52)

52
XWR-1750
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XWR-1750 Vers: 022515
APPENDIX 1: COMMON COMMANDS
Common Commands Description
Cmd Enter the command line mode of a Windows system (applicable to
Windows2000 and higher).
ipconfig Displays the IP address of any network adapters on the computer. (i.e.
ipconfig /all) Must be run from the command line.
Ping Used to test for network connectivity and device/system recognition.
A device sends a packet to the target host and asks for a response. If
the device receives a response from the target host, it can then see
the network response time and connection status between the local
device and target host. (i.e. ping 192.168.0.1) Must be run from the
command line.
netstat Displays details of active network connections including routing table
and network interface information. Can also be used to count the
active network connections. Must be run from the command line.
Tracert Displays the path taken by a packet before reaching the target host
and the specific time when it reached each node. Similar to the Ping
command, but provides more detailed information. Displays the entire
path and IP address of each node in the path and total elapsed time.
Must be run from the command line.