Luxul XFS-1816P - Manual (Page 5)

Simply Connected
© 2015 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
5
Network Ports
f 16 10/100Mbps RJ-45 ports (Ports 1~16), that support Auto MDI/MDIX.
f 2 Gigabit uplink ports
f 1 shared Gigabit SFP port.
NOTE: The SFP expansion port cannot support optical connections until
equipped with an SFP (Mini GBIC) optical module.
NOTE: When powering up, the port LEDs corresponding to the optical
interface may take a moment to initialize. This is normal as the
XFS-1816P does not detect the optical connection until after the
initialization and startup of internal software systems are completed.
NOTE: To extend your wired network connections beyond 300 feet, an optical
connection will be required. Please contact your Luxul representative or
go to our website to learn more about optical fiber, SFP optical modules
and optical network installation.
Rear Panel
The rear panel provides an AC input socket and power on/off switch. Use the included
power cable to connect the XFS-1816P to a surge protected outlet. The built-in high-perfor-
mance switching power supply of the XFS-1816P supports an input range of: AC 100-240V,
50/60Hz 3A.
INSTALLATION PREPARATION
System and Environmental Requirements
f Network cables to connect the XFS-1816P to Ethernet enabled devices
f A computer supporting TCP/IP and equipped with a Web browser. Supported Web browser ver-
sions include Microsoft IE 9.0 and up, Safari 5.0, and up or, Chrome 6.0, Opera 10.6, Mozilla Firefox
3.6 and up. The Web browser is used to configure the XFS-1816P.
f Power must be AC 100 ~ 240V, 50/60Hz 3A.
f Temperature of the operating environment should be: 32F~113F (0C~45C). Place the switch away
from heat generating devices. For best performance and heat dissipation/ventilation, make sure
there is adequate space around the switch.
f Humidity of the operating environment should be: 5%-95% non-condensing. Do not place the
switch in an extremely dirty or damp location.
f Keep the switch away from strong electromagnetic fields (i.e. Air Conditioner compressors, fluores-
cent light ballasts, CRT monitors/televisions, etc.), and free from vibration, dust and direct sun light.