LW Measurements CSS 440 Small Shipping Scale - Manual (Page 3)

6 5
9.2 Press “ [UNIT]” key to select auto-on(BALIAt), Backlight on(BALIon) and
Backlight off(BALIoF)
9.3 Press “
[HOLD/TARE]” key to confirm.
10. One point calibration
10.1 Once the scale is on, press and hold “PCS” and “UNIT” for 2s to access
into the calibration selection.
10.2 LCD display shown “C-kg”.
10.3 Press “
[UNIT]” key to select between “C-kg” and “C-lb” and press
“ [HOLD/TARE]” to confirm.
10.4 LCD display shown “C-XX” (remind user to place an equivalent weight
on the scale).
10.5 KG: “C-50” and “C-100”, LB: “C-100” and “C-200”.
10.6 Press “
[HOLD/TARE]” to confirm and turn off the scale.
10.7 Press “ [HOLD/TARE]” and “[UNIT]”, and press ““[ON/OFF]” to turn on
the scale.
10.8 LCD display shown “CAL” and shown “r-200”.
10.9 Press “
[UNIT]” to select the correct capacity of the scale and press
“ [HOLD/TARE]” to confirm. (CSS440 refer to “r-200”)
10.10 LCD display shown the internal code (5000-15000) and press
“
[HOLD/TARE]” to confirm.
10.11 LCD display shown “C-XX” (according to the setting set on 10.5).
10.12 Place an equivalent weight as display shown and pressing
“
[HOLD/TARE]” to confirm once reading is stable.
10.13 LCD display shown “ END” = completed or “Err1” = failed and turn off
the scale automatically.
Saftety Precautions
Caution
Avoid installing the scale in direct sunlight, this may cause discoloration or
malfunctions.
Do not mix the type of batteries. Replace all other batteries at the same
time.
If the scale is not to be used for a long period of time, remove all batteries
from the battery compartment to avoid leakage which may cause damage
to the instrument.
Avoid overloading, it could cause damage to the scale.
Do not drop water onto the scale as it’s not a water-resistant unit. If inside of
the scale is wet, it may damaged.