DreamGEAR ELITE VSX-94TXH - Manual (Page 34)

Using the tuner 06
34
En
Chapter 6:
Using the tuner
Listening to the radio
The following steps show you how to tune in to FM and
AM radio broadcasts using the automatic (search) and
manual (step) tuning functions. If you already know the
frequency of the station you want, see
Tuning directly to a
station below. Once you are tuned to a station you can
memorize the frequency for recall later—see
Saving
station presets on page 35 for more on how to do this.
1 Press the TUNER button to select the tuner.
2 Use the BAND button to change the band (FM or
AM), if necessary.
Each press switches the band between FM and AM.
3 Tune to a station.
There are three ways to do this:
Automatic tuning
To search for stations in the currently selected band,
press and hold
TUNE
/ for about a second. The
receiver will start searching for the next station,
stopping when it has found one. Repeat to search for
other stations.
Manual tuning
To change the frequency one step at a time, press
TUNE
/.
High speed tuning
Press and hold
TUNE / for high speed tuning.
Release the button at the frequency you want.
Improving FM stereo sound
If the TUNED or STEREO indicators don’t light when
tuning to an FM station because the signal is weak, press
the
MPX button to switch the receiver into mono
reception mode. This should improve the sound quality
and allow you to enjoy the broadcast.
Using Neural THX
This feature uses Neural Surround™ technology to
achieve optimal surround sound from FM radio.
• While listening to FM radio, press S.DIRECT for
Neural THX listening.
See About Neural Surround on page 92 for more on this.
The Neural THX mode can be selected also with the
STANDARD button.
Tuning directly to a station
Sometimes, you’ll already know the frequency of the
station you want to listen to. In this case, you can simply
enter the frequency directly using the number buttons on
the remote control.
1 Press the TUNER button to select the tuner.
2 Use the BAND button to change the band (FM or
AM), if necessary.
Each press switches the band between FM and AM.
3 Press D.ACCESS (Direct Access).
4 Use the number buttons to enter the frequency of
the radio station.
For example, to tune to
106.00 (FM), press 1, 0, 6, 0, 0.
If you make a mistake halfway through, press D.ACCESS
twice to cancel the frequency and start over.
SLEEP ANALOG
ATT
DIMMER
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
DVD TV BD TV CTRL
DVR1 i Pod TUNER RECEIVER
CD
DVR2 HOME MEDIA GALLERY
CD-R XM RADIO
SIRIUS ZONE2/3 
 HDMI
CLEAR
+10 DISC
CLASS D.ACCESS
ENTER
TV CONTROL
VOL
ST ST
TV CH INPUT
SELECT
INFO
MUTE
REC
TV VOL
ENTER
A PARAMETER
TOP MENU 
V PARAMETER
MENU T.EDIT
BAND
PROGRAM
GUIDE
RETURN RETURN SETUP SETUP
CATEGORY

ANT
CH LEVEL


TUNE
TUNE
SHIFT
STATUS STATUS
MCACC S.DIRECT
MULTI OPE
SIGNAL SEL
T.DISP
SBch STEREO/ F.S.SURR
MEMORY MPX
AUDIO SUBTITLE
ADV. SURR STANDARD
PHASE
THX
INFO
MUTE
REC
REC STOP
HDD
CH CH
DVD
DISP
RECEIVER
PHOTO
ANT
VSX_94TXH.book Page 34 Friday, April 27, 2007 8:21 PM