Mossberg 590 User Manual

Page 8

Advertising
background image

6

Discharging firearms in poorly ventilated areas, cleaning firearms, or handling

ammunition may result in exposure to lead and/or substances known to cause birth

defects, reproductive harm, and/or other serious physical injury. Have adequate

ventilation at all times. Wash hands thoroughly after exposure.

firing

With the firearm pointed in a safe direction and held in the proper firing position, move the safety

button fully forward to its “OFF” (FIRE) position. Pulling the trigger through its full travel to the rear

will cause the firearm to fire. Ensure muzzle is pointed in a safe direction before placing finger on

trigger.

Should the shotshell fail to fire, keep the firearm pointed in a safe direction and move

the safety button fully rearward to the “ON” (SAFE) position. Wait a few moments and

then remove the misfired shell and keep separate from other ammunition. Do not

attempt to refire a misfired round.

If at any time during firing, the sound of any shell is noticeably louder or softer than the

previous shells fired, STOP! Do not load or fire additional shells until you have put

safety in the “ON” (SAFE) position and safely unloaded your firearm. Inspect the

firearm for possible damage or obstructions in the chamber or bore. (The bore is the

inside surface of the barrel.) Firing the shotgun with a bore obstruction can cause

damage to the firearm and may result in serious personal injury to the shooter and/or

others nearby.

cycling The acTion

To eject a shotshell case, pull the forearm completely rearward. The spent case or

unfired shotshell will eject out of the receiver through the ejection port.

Be sure that all observers are clear of the path of ejection. Empty cases are thrown out

with significant force and could cause injury.

To chamber a live shotshell from the magazine, push the forearm fully forward.

Remember: when the magazine tube is loaded and the action is cycled, a live shotshell

will be chambered! Always keep the safety in the “ON” (SAFE) position until you have

actually decided to fire.

loaDing magaZine

Load the magazine tube by turning the shotgun so that the trigger guard is facing up and the

action is closed. Push the front end of the shell into the magazine tube until the rim of the shell

snaps past the cartridge stop (Fig. 6 & 9). Never attempt to exceed the magazine capacity.

Advertising
This manual is related to the following products: