2 ports configuration – Draytek 2130 User Manual
Page 125
Vigor2130 Series User’s Guide
117
equal to or less than 15, or "No Limit". The unit of the rate can
be either pps (packets per second) or kpps (kilopackets per
second). The configuration indicates the permitted packet rate
for unicast, multicast, or broadcast traffic across the switch.
4
4
.
.
4
4
.
.
2
2
P
P
o
o
r
r
t
t
s
s
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
This page is used to configure the ACL (Access Control List) parameters for each port. These
parameters will affect data packets received on a port unless the data packets match a specific
ACE (Access Control Entry).
Port
There is one WAN port and 4 LAN ports in Vigor2130. Here
each port will be configured with different ID, action, rate
limiter ID, port copy and etc.
Policy ID
Select a policy to apply to this port. The range for values is
from 1 to 8. The default value is 1.
Action
Select whether forwarding is permitted ("Permit") or denied
("Deny"). The default value is "Permit".