D-Link DAP-1160 - Manual (Page 36)

6 D-Link DAP-1160 User Manual
Section  - Security
Configure WEP
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based configuration by
opening a web browser and entering the IP
address of the access point (192.168.0.50).
Click on Wireless Settings on the left side.
2. Next to Security Mode, select Enable WEP
Security.
3. Next to Authentication, select Shared Key
or Open.
4. Select either 64-bit or 128-bit encryption
from the drop-down menu next to WEP
Encryption.
5. Next to Key Type, select either Hex or
ASCII.
Hex (recommended) - Letters A-F and
numbers 0-9 are valid.
ASCII - All numbers and letters are
valid.