ParkZone PKZ5380 - Manual (Page 8)

8
en
Landing Gear
Installation
1. Install left landing gear plate in wing using 4 screws.
Note: The short screw (M3 X 15) is installed in the rear holes
of the fixed landing gear.
2. Install landing gear strut in plate.
3. Install cover on strut using 2 screws.
4. Install wheel on strut using collar.
Note: Make sure bushing side of the wheel is toward the bend in the strut.
5. Tighten setscrew in collar.
Note: Threadlock may be required to keep the collar on the strut.
6. Install right landing gear the same as left landing gear.
Note: Refer to other instructions for retractable landing gear installation.
Removal
1. Loosen setscrew in collar.
2. Remove collar and wheel from strut.
3. Remove 2 screws and cover from plate.
4. Remove strut from plate.
5. Remove 4 screws and plate from wing.
Note: The short screws M3 x 15 are
installed in the two rear holes when
using the fixed gear or the two front
holes if using optional retractable
landing gear.
M2.5 X 10
M3 X 15
M3 X 20
Note: Not to scale. Wiring is not
shown. Tape is not shown.
Belly Skid
Attach clear plastic belly skid to bottom of
fuselage using double-sided tape.
Note: The belly skid is recommended if flying
without landing gear.