ParkZone PKZ6180 - Manual (Page 10)

EN
1. Remove the canopy from the fuselage.
2. Turn the wing and fuselage over so their bottom sides face up.
3. Place the wing’s aileron servo connectors (A) into the hole in the fuselage.
4. Slide the two guide pins (B) at the rear of the wing into the two holes in
the fuselage.
5. Align and attach the wing to the fuselage using two screws (C).
6. Inside the fuselage, connect both aileron servo connectors to the aileron
Y-harness connectors. The left and right aileron servos can be connected to
either side of the Y-harness.
When needed, disassemble in reverse order.
CAUTION: DO NOT crush or otherwise damage wiring when attaching
the wing to the fuselage.
Control Surface Centering and
Installing Clevises on Control Horns
Tip: Turn the clevis on the linkage to change the length of the linkage
between the servo arm and the control horn.
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired
hole in the control horn.
• Move the tube to hold the clevis on the control horn.
After binding a transmitter to the model receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.
A
B
Installing the Wing
1.
2.
3.
4.
5.
6.
C
10