Operating heater, Continued – Desa GWN10 User Manual

Page 13

Advertising
background image

107902-01D

13

13

For more information, visit www.desatech.com

For more information, visit www.desatech.com

LOW

OFF

PILOT

HIGH

OFF

PILOT

OFF

WARNING: When running heater, set control knob

at LOW or HIGH locked positions. Never set control
knob between locked positions. Poor combustion and
higher levels of carbon monoxide may result.

CAUTION: Do not try to adjust heating levels by

using the equipment shutoff valve.

1.

Slightly press in control knob and turn
counterclockwise

to the LOW or HIGH positions.

IMPORTANT:

Release downward pressure while turning

control knob. Control knob will lock at the desired position.

OPERATING HEATER

Continued

TO SELECT

HEATING LEVEL

Control

Knobs

Burners

Figure 21 - Burner Patterns

Shutting Off Heater

Turn control knob clockwise

to the OFF position.

Shutting Off Burner Only (pilot stays lit)

Turn control knob clockwise to the PILOT position.

TO TURN OFF GAS

TO APPLIANCE

OPERATING HEATER (Manual Control Infrared Models)

To Select Heating Level

To Turn Off Gas To Appliance

Manual Lighting Procedure

OPERATING HEATER (Thermostat Control Blue Flame and Infrared Models)

For Your Safety Read Before Lighting

1.

Remove front panel (see Figure 10, page 8).

2.

Follow steps 1 through 5 under Lighting Instructions,
page 12.

3.

With control knob pressed in, strike match. Hold match to
pilot until pilot lights.

4.

Keep control knob pressed in for 10 seconds after pilot is
lit. After 10 seconds, release control knob.

5.

Replace front panel.

THERMOSTAT CONTROL BLUE FLAME

AND INFRARED MODELS

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not follow these instructions

exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.

A. This appliance has a pilot which must be lighted by hand.

When lighting the pilot, follow these instructions exactly.

B. BEFORE LIGHTING smell all around the appliance area

for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in

your building.

• Immediately call your gas supplier from a neighbor’s

phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire de-

partment.

C. Use only your hand to push in or turn the gas control knob.

Never use tools. If the knob will not push in or turn by
hand, don’t try to repair it, call a qualified service techni-
cian or gas supplier. Force or attempted repair may result
in a fire or explosion.

D. Do not use this appliance if any part has been under water.

Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.

MANUAL LIGHTING

PROCEDURE

Advertising
This manual is related to the following products: