ParkZone PKZU1480 - Manual (Page 10)

10
Propeller and Propeller Shaft Maintenance
EN
Remove
Diassembly
1. Carefully cut tape and decals on fuselage
and turtle deck (top of fuselage behind
canopy) and remove top of fuselage.
Note: Removing tape or decals will remove
paint from the fuselage.
2. Hold the prop shaft using needle-nose
pliers or hemostats.
3. Turn propeller counterclockwise
(looking from front of model) to remove.
Turn propeller clockwise to install.
4. Carefully remove a damaged spinner
and glue from propeller.
5. Hold nut on end of prop shaft using
needle-nose pliers or hemostats.
6. Turn gear on shaft clockwise (looking
from front of model) to remove nut.
7. Cut a small amount of foam from fuselage
before removing prop shaft.
8. Gently pull shaft (A) from gearbox (B)
and make sure washer (C) and
two bushings (D) are not lost.
9. Disconnect motor from ESC/receiver.
10. Gently push motor out of gearbox and
remove motor through top of fuselage
behind the ESC/receiver.
NOTICE: DO NOT remove gearbox from
model. Damage to model will result.
Assembly
Assemble model using instructions above,
in reverse order.
• Correctly align prop shaft gear with
pinion gear on motor.
• Correctly connect motor to ESC/receiver
so that powered motor turns propeller
clockwise (looking from front of model).
• Attach spinner to propeller using CA or
foam-compatible CA.
• Assemble fuselage using clear tape.
A D
B
C
Install
CAUTION: DO NOT handle propeller
parts while the fl ight battery is
connected. Personal injury could result.