Instructions, Ganciomatic system – Peg-Perego Triplette SW Stroller Chassis User Manual

Page 10

Advertising
background image

INSTRUCTIONS

1 FITTING THE WHEELS: remove the four protective caps, (two round and two square) from

the folded chassis, as in the figure.

2 WARNING: distinguish the front wheels (Fig. A) from the rear wheels (Fig. B), as in the figure.

3 Fit the front wheels, which are shown in Figure A, while the base is closed. It is necessary

to push the locking lever down (fig. B) and at the same time push the hub onto the pin (fig.
C). Check that the wheels are properly attached by pulling them in opposite directions.

4 To fit the rear wheels, repeat the action carried out for the front wheels (sequence B and C).

The rear wheels can be identified by the black teeth, as shown in figure A. Check that the
wheels are properly attached by pulling them in opposite directions.

5 BRAKE: to activate the brake on the chassis, push down with your foot on the brake bar

located on the rear wheels, as shown by the arrows in the figure.

6 OPENING: activate the brake on the folded chassis. Unfasten the tab, as in the figure.

7 Lift the handlebar in the direction of the arrow (Fig. A). Press the handlebar downwards until

the final click (Fig. B).

8 Check that the opening is correct, as in the figure.

9 BASKET: fasten the basket on the chassis base, as shown in the figure, at six specific

points. Attach the four buttons, to the front and rear, as in figures A and B; then attach the
two Velcro strips to the chassis tube, as in figure C.

10

STEERING WHEEL: to guarantee good grip, the steering wheel may adopt four different
positions. To adjust them, press the button as in the figure.

11

STEERABLE WHEELS: the practical steering wheel allows you to steer the front wheels.
To steer, move the lever on the steering wheel to the right, as in figure A. To fix the wheels,
move the lever to the left, as in figure B.

12

WHEEL REMOVAL: press down on the lever at the centre of the wheel, as shown by the
arrow in figure A, and simultaneously pull the wheel towards you (Fig. B).

13

FOLDING: activate the brake and release the seats. To fold the chassis, lift the lever on the
handlebar (Fig. A), thus detaching the handlebar, and move it slightly forwards (Fig. B). Push
down on the safety lever with your left foot (Fig. C) to release the handlebar.

14

Rotate the handlebar downwards (Fig. A). Fold the chassis, attaching the tab to the
handlebar fastener (Fig. B).

GANCIOMATIC SYSTEM

Ganciomatic is a fast and practical system that allows you to attach the Primo Giro carrying

chair or the Primo Viaggio car seat (sold separately) to the Ganciomatic Base in one step.

Place the item on the Ganciomatic Base and push down with both hands until you hear a click.

Always activate the chassis or stroller brake before attaching or removing products (refer to

the respective instruction manuals).

Follow the instructions for the product combinations.

15

TRIPLETTE SW + 3 CARRYING SEATS

WARNING: To keep the product steady, we recommend installing all three carrying seats at

all times.

If for any reason Triplette SW is used with only one or two occupants, we recommend

fastening all three carrying seats securely to the chassis in any case.

Place the child or children in the seats nearest the steering wheel.

Advertising