Desa EFS10TN - Manual (Page 14)

107032-01E
For more information, visit www.desatech.com For more information, visit www.desatech.com
14
Red
Red
Fan Switch
(Auto/Off/On)
Blue
Blue
Thermostat
Switch
(N.O.)
Green
White
Green
White
On
110/115
V.A.C. Blower
Motor
Black
Off
1
2
3
Auto
Figure 20 - Installing Blower Bracket Assembly
Figure 19 - Wiring Diagram For Blower Accessory Built-In
Installation
INSTALLATION
Continued
Blower Bracket
Assembly
Screw
Wire Harness
Plastic
Wire Strap
Wire Harness
Switch
Plate
Switch
Clamp Connector
(not included)
Blue
Red
Outlet Receptacle
(Not Supplied)
Figure 21 - Removing Upper Louver Assembly
Upper Louver
Assembly
Brass
Screws
3. A licensed electrician must follow the wiring diagram to con-
nect incoming electrical supply to fan kit wiring harness (see
Figure 19).
4. Plug power cord to the outlet receptacle (not provided) as shown
in Figure 20. Wind the extra cable in power cord and and tie it
up with the plastic wire strap (see Figure 20). Set the cable
bundle between the burner bracket and outer casing, away from
the burner.
5. Test to make sure the blower is working properly.
6. Reinstall upper louver assembly (see Figure 15, page 12) and
close lower louver.
INSTALLING OPTIONAL BLOWER
ACCESSORY GA3450T IN THERMOSTAT-
CONTROLLED MODELS
Removing Upper Louver Assembly
To install the blower accessory, you must first remove the upper
louver assembly.
1. Remove 4 screws from upper louver assembly (see Figure 21).
Save these screws.
2. Pull upper louver assembly straight out from the cabinet. Be care-
ful not to scratch the paint. Set louver assembly and screws aside.
Blower Bracket
Mounting Holes
Power
Cord
Extension Cord
Use extension cord if needed. The cord must have a three-prong,
grounding plug and a three-hole receptacle. Make sure cord is in good
shape. It must be heavy enough to carry the current needed. An
undersized cord will cause a drop in line voltage. This will result in
loss of power and overheating. Use a No. 16 AWG cord for lengths
less than 50 feet.
Lower Louver Door
Black
INSTALLATION
Installing Blower Accessory GA3450T in Remote-Ready Models (Cont.)
Installing Blower Accessory GA3450T in Thermostat-Controlled Models