Desa EFS10TN - Manual (Page 5)

107032-01E
For more information, visit www.desatech.com For more information, visit www.desatech.com
5
5
ASSEMBLY
Assembling Fireplace
ASSEMBLY
ASSEMBLING FIREPLACE
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
• scissors
1. Remove two screws that hold fireplace screen in place for ship-
ping. These screws are located near top of screen. Discard
screws. Lift fireplace screen up and pull out to remove. Set
screen aside until installation has been completed.
2. Cut two plastic straps to remove the log from the firebox cavity.
3. An optional blower is available. See Accessories, pages 38 and
39. Install optional blower now. Follow installation instruc-
tions provided with blower. See page 12 for Remote-Ready
Models or page 14 for Thermostat-Controlled Models.
Figure 3 - Removing Screen
WARNING: Always have branch support and
screen in place before operating fireplace. This pre-
vents excessive temperatures on fireplace surfaces.
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this fireplace may result in
property damage or personal injury.
Screen
Burner Support With
Log Locator Tabs
Branch
Support
Shoulder
Screw
Figure 4 - Assembling Hood
Hood Tab
4. Locate four black phillips sheet metal screws from the hard-
ware packet.
5. Rotate hood as shown in Figure 4. Make sure hood tabs
point toward fireplace.
6. Insert hood tabs between baffle and louvers (see Figure 4).
7. Gently rotate hood to upright position. Make sure hood tabs
are behind louvers and hood is resting on firebox top (see
Figure 4).
8. Align screw holes on hood with screw holes on firebox top.
9. Insert screws as shown in Figure 4. Tighten screws firmly.
Sheet Metal Screws
Louver
Baffle
Firebox Top
Hood
Hood Tabs