Portable Winch Gas-powered pulling/lifting winch PCH1000 - Manual (Page 20)

20
PERFORM A TEST PULL WITH A LIGHT LOAD IN ORDER TO ASSES
VEHICLE STABILITY AND EQUIPMENT INSTALLATION.
1) Figure 1: Slide the square tubing (PCA-1267) into the vehicle’s receiver and secure it with
both the hitch pin and the ‘’R’’ pin;
2) Figure 2: Insert the vertical pull winch support onto the square tubing, align the holes and
insert the pulley;
3) Figure 3: Tighten the nut with your fingers until it touches the support. Then reinforce it
with the ‘’R’’ pin;