08 prw ssr rocker install guides1722 v1.5b – PRW 08 PRW Sportsman Series Steel Roller Tip Rocker Arms User Manual
Page 2
the camshaft for that particular cylinder. That is the point in the firing order of each cylinder where the
intake valve lash may be adjusted as detailed in Step 5.
Step 7
Adjusting Exhaust Valves: Hand turn the crankshaft until the intake pushrod has reached maximum lift
and is between one half and two thirds of the way back down. This will indicate that the exhaust valve
lifter is at the “base circle” for that particular cylinder. That is the point in the firing order of each
cylinder where the exhaust valve lash may be adjusted as detailed in Step 5.
Step 8
Check for clearances. Always make certain that the rocker does not come in contact the lower portion of
the rocker arm stud, guide plate, or the stud boss of every cylinder. Also, check the clearance between the
spring and the body of the rocker. This should be a minimum of 0.040”. Normally, the smallest amount
of clearance occurs when the valve is closed and the lifter is at “base circle”. Always hand turn the crank
to verify there is proper clearance of the rocker arm throughout the entire travel of the valve.
Step 9
Before installing the valve covers for the final time, check for proper clearance between rockers and valve
covers. Finally, install or reinstall the valve covers on the cylinder heads.
Limited Warranty
Performance Quotient and PRW Industries, Inc. (“PRW”) warrants that all of its products are free from defects in
material and workmanship for a period of (1) one year from the date of purchase. This limited warranty shall cover
the original purchaser.
PRW’s obligation under this warranty is limited to the repair or replacement of its product.
To make a
warranty claim, the part must be returned within (1) one year of purchase to the address listed below, freight
prepaid. Items covered under warranty will be returned to you freight collect.
It is the responsibility of the installer to ensure that all of the components are correct before installation.
PRW assumes no liability for any errors relative to tolerances, component selection, or installation.
There is absolutely no warranty on the following:
i. Any parts used in racing applications, or;
ii. any product that was physically altered, improperly installed or maintained, or;
iii. any product used in improper applications, abused, or not used in conjunction with the
proper parts.
There are no implied warranties of merchantability or fitness for a particular purpose and no warranties
which extend beyond the description of the face hereof.
PRW will not be responsible for incidental and consequential damages, property damage or personal injury damages
to the extent permitted by law. Where required by law, implied warranties or merchantability and fitness are limited
for a term of one year from date of original purchase. This warranty may give you specific legal rights. You may
have other legal rights, which vary from state to state.
PRW Industries, Inc.
1722 Illinois Avenue
Perris, CA 92571
Tel: (951) 436-7900 Fax: (951) 928-8555
Tech: (888) 377-9779
www.PRW-USA.com