PRW 18 PQ Signature Series Cummins Billet Steel Flexplate (SFI-Rated 29.3) - Manual (Page 2)

STOP!!!!
SPECIAL NOTES:
Before installing this flexplate, make certain that the application is correctly identified for your vehicle’s engine, that the
counterweight is correct for your application, the flexplate bolt pattern is correct for your make and model, and ring gear
tooth count is correct. No returns are permitted for flexplates or flywheels that have been installed! PRW is not
responsible for installation issues or mismatched parts.
Flexplates are designed to allow for the “ballooning” that occurs at higher RPM. In most cases, our Platinum Series
flexplates will work for street use. However, many require specialty drain plugs and other considerations not generally
known by the end user.
Also, the Platinum Series flexplates are designed for “severe duty”, and as such do not flex like an OEM flexplate. For
that reason, these parts should be installed by trained personnel that understand the additional “clearances” that may be
required to compensate for the torque convertor ballooning that occurs under severe loads and/or high engine RPM.
Failure to do so may result in damage to the transmission pump and/or other transmission components.
CUMMINS and DODGE DIESEL FLEXPLATES
There are many variations and combinations of Cummins diesel engines and transmissions between 1989 and
2005+. The PRW flexplate for this application is designed for high performance and racing.
Do not install this flexplate if there is less than 0.125” clearance between the torque converter and flexplate.
PRW recommends that this application be installed by a professional mechanic or transmission specialist with
specific knowledge of Cummins engine/torque converter and transmission requirements.
LIMITATION OF WARRANTY
Performance Quotient and PRW Industries, Inc. (“PRW”) warrants that all of its products are free from defects in material
and workmanship, and against excessive wear for a period of (1) one year from the date of purchase. This limited
warranty shall cover the original purchaser.
PRW’s obligation under this warranty is limited to the repair or replacement of its product. To make a warranty
claim, the part must be returned within (1) one year of purchase to the address listed below, freight prepaid. Items covered
under warranty will be returned to you freight collect.
It is the responsibility of the installer to ensure that all of the components are correct before installation. PRW
assumes no liability for any errors relative to tolerances, component selection, or installation.
There is absolutely no warranty on the following:
i. Any parts used in racing applications, or;
ii. any product that has been physically altered, improperly installed or maintained, or;
iii. any product used in improper applications, abused, or not used in conjunction with the proper
parts.
There are no implied warranties of merchantability or fitness for a particular purpose and no warranties which
extend beyond the description of the face hereof.
PRW will not be responsible for incidental and consequential damages, property damage or personal injury damages to the
extent permitted by law. Where required by law, implied warranties or merchantability and fitness are limited for a term
of (1) one year from the date of original purchase. This warranty may give you specific legal rights. You may also have
other legal rights, which vary from state to state.
PRW Industries, Inc.
1722 Illinois Avenue
Perris, California 92571
Tele: (951) 436-7900 FAX: (951) 928-8555
Tech: (888) 377-9779
www.prw-usa.com