PRW 25 PQ Series Racing FluidGel Harmonic Damper (SFI-Rated 18.1) - Manual (Page 2)

Timing Check
Step 1
Check the ignition timing marks. Note: some engines have been equipped with different timing tabs over the years.
Step 2
Use the positive stop method to locate the true TDC (Top Dead Center). Relocate the timing tab if necessary.
Limited Warranty
Performance Quotient and PRW Industries, Inc. (“PRW”) warrants that all of its products are free from defects in material and workmanship, and
against excessive wear for a period of (1) one year from the date of purchase. This limited warranty shall cover the original purchaser.
PRW’s obligation under this warranty is limited to the repair or replacement of its product. To make a warranty claim, the part must be
returned within (1) one year of purchase to the address listed below, freight prepaid. Items covered under warranty will be returned to you freight
collect.
It is the responsibility of the installer to ensure that all of the components are correct before installation. PRW assumes no liability for any
errors relative to tolerances, component selection, or installation.
There is absolutely no warranty on the following:
i. Any parts used in racing applications, or;
ii. any product that has been physically altered, improperly installed or maintained, or;
iii. any product used in improper applications, abused, or not used in conjunction with the proper parts.
There are no implied warranties of merchantability or fitness for a particular purpose and no warranties which extend beyond the
description of the face hereof.
PRW will not be responsible for incidental and consequential damages, property damage or personal injury damages to the extent permitted by law.
Where required by law, implied warranties or merchantability and fitness are limited for a term of (1) one year from the date of original purchase.
This warranty may give you specific legal rights. You may also have other legal rights, which vary from state to state.
Pulley Installation
Step 1
Install the pulley onto the damper with damper or pulley mandrel. If mandrel is not used this could lead to side loads on the crankshaft. If necessary,
drill new bolt holes in the pulley. Do not drill new holes in the damper. This could lead the damper to leak and void the warranty.
Notes: 1) P/N’s 2545501 & 2545511 do not match stock pulley holes. For matching pulley refer to March Performance P/N 13041, and 2) P/N’s
2539001 & 2539011 require aftermarket pulleys. Please refer to March Performance P/N 1971 for 1V pulley, P/N 1973 for 2V pulley, P/N 1975 for
3V pulley.
Step 2
Hand turn crank to insure there is no wobble to the damper or pulley.
If you need technical information, or additional information regarding
the installation of this product please call us.
p:\product\installation guides\ms word\25 pq fluid dampers 1722 v1-3.doc
PRW Industries, Inc.
1722 Illinois Avenue
Perris, California 92571
Tele: (951) 436-7900 FAX: (951) 928-8555
Tech: (888) 377-9779
www.prw-usa.com
Email: [email protected]