Rocktron VP4 - Manual (Page 8)

8
Fuse Replacement
Fuse Replacement
Always replace the main fuse with an identically rated replacement. Your VEN-
DETTA amplifier uses a 3AG, 2A, 250VAC, slo-blo fuse for 100/120VAC or 3AG,1A,
250VAC slo-blo fuse for 220/240VAC.
The fuse is located immediately below the line cord inlet on the rear panel and can
be accessed by removing the fuse cover module as shown below.
R E P L A C I N G T H E F U S E
Use a small flat screwdriver as shown to slide the
fuse cover/voltage selector out from the power
inlet module. The fuse can be found inside the
fuse cover module after it is pulled out.
After replacing the fuse with another of identical
specifications, push the fuse cover module fully
back into place, ensuring that the fuse has
snapped onto the fuse holder inside the power
inlet module and the voltage selector is set to the
proper voltage.
Voltage Indicator:
This is noted by the small arrow. Make sure when
replacing a fuse or if you are playing in a different
country with different voltage that you properly
replace the fuse so that the voltage of the country you
are playing in is next to the Voltage Indicator arrow.
1
2
3