Rocktron Rampage R80 - Manual (Page 7)

3
Rear Panel Controls
REV/CH FTSW (Reverb/Channel Footswitch)
Remote control CHANNEL selection and REVERB ON/OFF with a
footswitch. To control CHANNEL selection, plug a single footswitch*
into the input. To control CHANNEL selection and REVERB ON/OFF,
use a double footswitch* with a stereo 1/4" jack.
EFFECTS - RETURN / SEND jacks
1/4" jacks to connect a separate effects processor to the amplifier.
OUTPUTS - PREAMP
1/4" jacks to connect to other electronic equipment like mixers, tape
recorders or amplifiers. The volume level of the signal coming from
these jacks is NOT controlled by the Master Volume Control.
OUTPUTS - LINE OUT
One 1/4" jack to connect to other electronic equipment. The signal's
volume is controlled by the Master Volume Control.
* Rocktron Rampage single (RFS1) and double (RFS2) footswitches are
available and sold separately.
1
3
4
2
1
2
3
4
AGX™ (Automatic Gain Expander)
Rocktron's patented AGX™ system solves the long standing problem encountered by guitar players
when using high gain distortion. The AGX™ circuit expands the gain of the amplification circuit only when
required based on the input level. When no signal is present, the AGX™ circuit expands down the amplifi-
cation level to a point where hum and noise are dramatically reduced.