Rocktron Rampage R120 - Manual (Page 7)

3
1 20 C
10
11
CHORUS FTSW (Footswitch) jack
Remote control CHORUS ON/OFF with a single footswitch* connected
to the input with a 1/4" jack.
REV / CH FTSW (Footswitch) jacks
To control CHANNEL selection, plug a single footswitch* into the input.
To control REVERB and CHANNEL selection, use a double footswitch*
with a stereo 1/4" jack.
EFFECTS RETURN / SEND jacks
1/4" jacks allow you to connect to an effects processor.
PREAMP OUTPUTS - (LEFT / RIGHT)
1/4" jacks allow you to connect to other equipment like mixers, tape
recorders or amplifiers. The volume level of the signal coming from
these jacks is NOT controlled by the Master Volume Control.
LINE OUTPUTS - (LEFT / RIGHT)
These 1/4" jacks allow you to connect to other equipment, and control
the volume level of the signal with the Master Volume Control.
* Rocktron Rampage single (RFS1) and double (RFS2) footswitches are
available and sold separately.
2
1
1 3 2
4 5
Rear Panel
PHONE (Headphone) jack
Plug your headphones into this jack to practice in private.
POWER switch
Turns the amp ON and OFF. A red LED shows the amp is ON.
3
4
5
AGX™ (Automatic Gain Expander)
Rocktron's patented AGX™ system solves the long standing problem encountered by guitar players
when using high gain distortion. The AGX™ circuit expands the gain of the amplification circuit only when
required based on the input level. When no signal is present, the AGX™ circuit expands down the amplifi-
cation level to a point where hum and noise are dramatically reduced.