Rocktron Velocity 100 - Manual (Page 9)

6
Fuse Replacement
Always replace the main fuse with an identically rated replacement. Your Velocity 100
amplifier uses a 5x20mm, 4A amp, 250V slow-blow fuse (2A, 250V slow-blow for 230VAC).
The fuse is located immediately below the line cord inlet on the rear panel and can be ac-
cessed by removing the fuse cover module as shown below.
Use a small flat screwdriver as shown to slide the fuse cover out from the power inlet module. The
fuse can be found inside the fuse cover module after it is pulled out.
G
Note: A small compartment
is also provided within the
fuse cover module for storing
a spare fuse.
After replacing the fuse with another of identical specifications, push the fuse cover module fully
back into place, ensuring that the fuse has snapped onto the fuse holder inside the power inlet
module.