Rocktron Velocity 250 - Manual (Page 7)

4
Rear Panel
Rear Panel
1 INPUT jack (Ch. 2)
2 OUTPUT jacks (Ch. 2)
3 115/230 selector switch
4 OUTPUT jacks (Ch. 1)
5 INPUT jack (Ch. 1)
6 POWER INLET module
This standard ¼" jack provides an input to Channel 2 from the
output of your preamp or the last device in your effects chain.
This jack is inoperable when using the Velocity 250 in "bridged"
mode (i.e STEREO/BRIDGED switched to "BRIDGED").
These standard ¼" jacks provide outputs for Channel 2 to speaker
cabinets. Do not connect these outputs to a load of less than 4
ohms (or less than 8 ohms in mono-bridged mode). These jacks are
inoperable when using the Velocity 250 in "bridged" mode (i.e
STEREO/BRIDGED switched to "BRIDGED").
This switch allows for easy setup between 115VAC and 230VAC.
Warning: Improper setting of this switch may cause
the unit to fail. Make sure the switch setting matches
the local AC mains voltage.
These standard ¼" jacks provide outputs for Channel 1 to speaker
cabinets. Do not connect these outputs to a load of less than 4
ohms (or less than 8 ohms in mono-bridged mode). These jacks are
used when using the Velocity 250 in "bridged" mode.
This standard ¼" jack provides an input to Channel 1 from the
output of your preamp or the last device in your effects chain.
This jack is used as the input jack when operating the Velocity 250
in "bridged" mode.
This module provides a connection for the power cord and also
houses the main fuse of the unit. (For information about changing
the fuse, see page 8).