Rocktron MicroHUSH - Manual (Page 6)

Descriptions continued.........
THRESHOLD Control - This control determines level of attack to cause the HUSH to
activate. Attack is measured in time. Threshold is measured in dB or by the voltage/level of
the signal.
9VDC Power Jack - The MicroHUSH requires 9VDC power to operate (not included/sold
separately). This 2.1mm power jack (Negative Tip/Positive Barrel) provides 9VDC power
to the pedal. We recommend the Rocktron DC OnTap Univeral 9V power supply. More
information on the DC OnTap Line of power supplies at the end of this manual.
ON/OFF Led - This LED shows if the pedal is on or off. When the LED is lit the pedal is
on. When the LED is not lit the pedal is off.
INPUT Jack - Using a standard 1/4” guitar cable, plug the cable from the output of the noisy
pedal into this jack.
FOOTSWITCH - Use this switch to turn on or off the pedal. The On/Off Led will show you
if the pedal is on or off.
OUTPUT Jack - Using a standard 1/4” guitar cable you can plug in another pedal from this
jack or plug directly into your amplifier.
1
2
3
4
5
6