Rocktron Metal Planet Distortion - Manual (Page 7)

Output - Using a standard guitar cable with a 1/4” jack, plug into
the input of your guitar amplifier or next stomp box in the signal
chain
On/Off Switch - This switch determines whether the pedal is
“active” or “bypassed” - When “active” the blue LED will be lit.
When bypassed the LED will not be lit.
Input - Using a standard guitar cable with a 1/4” jack, plug your
guitar into this jack.
DC 9V Input - To use external power (not provided) use only a
9-Volt DC adapter
9-Volt Battery Compartment - to access pull on small tab labeled
“OPEN”. Replace with a new 9-Volt battery. Always remember
to unplug your guitar cords from the pedal to conserve battery
life. Some battery drain may take place when unit is plugged in
(even if the unit is bypassed).
8
9
10
11
12
Left Side
Bottom
Right Side