Rocktron Utopia Bass Wah - Manual (Page 9)

ROCKER FOOTPEDAL - Place your foot on the rocker foot-
pedal and rock it up and down (toe to heel - heel to toe) to work
the “ wah” effect.
Wah ON/OFF Switch - is located under the toe of the rocker
footpedal. To activate the “wah” press down slightly harder on
the toe of the rocker pedal until the switch is activated. The
same process is to be applied to turn off the wah effect.
INPUT Jack - using a standard guitar/bass cable - plug your
bass into this jack.
9-VOLT ADAPTER INPUT - This receptacle requires a 9V DC
adapter (not included) with a 2.1mm coax plug to provide pow-
er to the unit. Please consider using the Rocktron DC OnTap
adapter (sold separately) available from your Rocktron dealer.
Note: If an adapter other than the Rocktron DC OnTap adapter is used, it needs to be a 9V DC
filtered audio grade type with a current rating of 100ma or greater . The plug is a 2.1mm Coax
jack (Tip is Negative and Sleeve is Positive). Please follow all instructions that appear on the
bottom of the Utopia Wah.
OUTPUT Jack - using a standard guitar/bass cable, plug this
output into the next effect in your effect chain or directly into the
input of your amplifier.
9-VOLT BATTERY COMPARTMENT - to access pull on
small tab labeled “OPEN”. Replace with a new 9-Volt battery.
Always remember to unplug your guitar cords from the pedal to
conserve battery life. Some battery drain may take place when
unit is plugged in (even if the unit is bypassed).
1
2
3
4
Controls and Function Descriptions
5
6