Rocktron Intellifex On-Line - Manual (Page 13)

10
Caution: Digital Output overload
As the input signal enters at the unit’s input (A), the unaltered direct signal is fed to
the Direct Pre/Post Hush Selector (B). Here you may choose for the direct signal to
remain unaltered (Pre) or feed it through the digital Hush section (E) of the Intellifex
Online (Post). Before being fed to the Hush section, the signal must first be converted
from an analog signal to digital via the converter (D). When the direct signal is fed to
the Hush section, it will remain digital until it is summed together with the output of
the Effects Level control (G).
It is important to remember that it is possible to overload the Digital to Analog
Converter (H) if the effects levels and direct signal level are set too high when using
the Hush section with the direct signal. If this occurs, reduce these levels until the
front panel CLIP L.E.D. does not light.
Also note that when passing the direct signal through the digital HUSH (Post), a
stereo signal will be converted to mono.
6. Principle of Operation
A. MIXER SECTION
The first function accessible when turning the FUNCTION SELECT control in any preset is
the Mixer function. This digital mixer allows you to control the signal levels pertaining to each
preset’s configuration and stores these levels for each preset.