Sonodyne AMC+60 - Manual (Page 4)

1 CH 1–4
These control the levels for each channel input.
2 Bass
There is 12dB of cut and boost at 100Hz.
3 Treble
There is 9dB of cut and boost at 10kHz.
4 Master
This controls the overall mixed output level.
5 On
This LED indicates the unit is powered “on”.
6 Power
This switch switches power on or off the mains. The up position is on.
5 6 2 3 4 1
NOTE:
For the model AMC+30
Risk of hazardous energy. Class 2 wiring should be used. The apparatus
should be disconnected from the mains completely before speaker
wiring. The speaker output should be proper protected from direct
contact and pay attention to speaker connections, terminals and
speaker wiring during normal operation.
For the model AMC+60, AMC+120, AMC+250
Risk of hazardous voltage. Class 3 wiring should be used. The
apparatus should be disconnected from the mains completely before
speaker wiring. The speaker output should be proper protected from
direct contact and pay attention to speaker connections, terminals and
speaker wiring during normal operation.
PAGE 4 AMC + SERIES INSTALLATION AND OPERATION MANUAL
FRONT PANEL