SOR Submersible Hydrostatic Level Transmitter - Manual (Page 2)

2/8 Form 948 (10.09) ©2009 SOR Inc.
Linear = mm/inches
Dimensions are for reference only.
Contact the factory
for certified drawings
for a particular model number.
Calibration
The transmitter is supplied factory calibrated and during normal use should not require
recalibration. If it is desired to verify calibration prior to installa tion of Series 510LT,
remove the nose cone and attach to a pressure source capable of adjustment
throughout specified range. If outputs are not within limits at factory calibration
conditions, 77°F (25°C), the device should be returned to the factory.
Units in hazardous locations - prior to removal from service, make sure
that the work area is declassifi ed.m Failure to do so could result in severe
personal injury or substantial property damage.
Drawing 0091085
Drawing 0091268