Speck Electronics LiLo - Manual

LiLo - Mixer Stand Assembly Instructions
Copyright © 2004-2008 by Speck Electronics. LiLo is an exclusive Trademark of Speck Electronics.
Information and specifications are subject to change without notice.
Sp e c k E l e c t r o n i c s • 3 4 1 E . A l v a r a d o S t r e e t , F a l l b r o o k , C a l i f o r n i a 9 2 0 2 8 , U S A
Voice: +760-723-4281 • Fax: +760-723-3294 • email: [email protected] • www.speck.com
[C] Cross brace
[D] Top tray
[B] Right upright support
[A] Left upright support
[G] 8-32 x 3/8” Pan Head Phillips
[E] 1/4”-28 x 1.5” Button head socket bolt
[F] Allen Key Wrench
Front
Rear
1. Install the button head socket bolt [E] through the upper hole of either the left or right support [A] or [B].
Note that the inside of the supports have (3) threaded holes at the top.
Screw this bolt into the upper threaded hole at either end of the cross brace [C]. Note that the bottom of the
cross brace has a cosmetic difference from the top. Hand tighten this bolt only.
2. Repeat this procedure for the other side of the support [A] or [B]. Hand tighten this bolt only.
3. Install the remaining (2) s [E] on each side. Hand tighten these bolts only.
4. Place the top tray [D] upside down on a clean flat surface. Place the partially assembled supports with
cross brace so the (3) threaded holes on each support are aligned with the (3) through-holes of the top tray
[D]. Install (6) Phillips screws [G], (three on each side) through these holes and tighten with a Phillips
screwdriver.
5. Once the top tray [D] has been attached to the supports and the Phillips screws [G] have been tightened,
use the supplied Allen key wrench [F] to tighten the (4)
[E].
6. This completes the assembly the stand. Place the assembled stand upright on the floor.
button head socket bolt
button head socket bolts
[E] 2 per side
[G] 3 per side
Now the LiLo mixer will be placed on the stand.
~Important~
Before placing the LiLo mixer on the stand, it is very
important that the stand is in the correct position to
receive the mixer. The front of the LiLo mixer must
be place over the long section of the stands base as
shown in [J].
7. Place the LiLo mixer on the stand so the center area
of the LiLo's side panels is positioned at the middle of
the upright support as shown in [H].
The rubber bumpers on the top surface of the stand
will prevent the LiLo mixer from sliding forward or
backward, so it will be necessary to lift the mixer away
from the stands' top tray in order to make fine
adjustments to the final position.
8. The final position of the mixer on the stand should
be set so the rear edge of the LiLo's side panels are
9.25” [235mm] from the rear edge of the support as
shown in [ I ].
9.25”
235mm
[ I ]
[J] Front of stand
[H]