Star Headlight & Lantern 274-RCK - STAR-RACK - Manual (Page 4)

-4-
9. If you are adding mounting plates/brackets, slide any
appropriate bolts into each slot based upon your application(s).
10 Replace the end cap and re-install the screws.
DO NOT OVER-TIGHTEN THE SCREWS. IF THE
SCREW HOLES ARE STRIPPED, THE SECURE
MOUNTING OF YOUR COMPONENTS MAY BE
COMPROMISED.
4. Determine where you wires from your
components will wrap under the bar and enter
the extrusion and cut the plastic window to the
desired length.
• Using a sharp utility knife, heavily score a
“snap” line on the plastic.
• Bend the plastic back and forth about the
scored line until it breaks.
(Component Installation CONT’D)
5. Route the wires from the first light under the extrusions (or over the top of the extrusion,
if applicable), connect them to the appropriate wires from the harness, and tuck the
connectors into the extrusion.
8. Once all plastic window pieces are in place, slide the front extrusion over the bolts and
back onto the assembly.
6. Measure the distance to the
wires from the next light and cut
another length of the plastic
window. Slide it into the
designated slot in the extrusion
as close as possible to the wires
from the first light.
7. Repeat steps 4-6 for each light you need to connect, cutting the last plastic window
piece to extend to the end of the extrusion.