Star Headlight & Lantern 66 Star Spectrum User Manual

Crs back-up alarms

Advertising
background image

PLIT444 REV. F 1/14/15

CRS BACK-UP ALARMS

Compact Reverse Speaker
























Dual Tone units emit an alternating high/low tone.
Auto-Adjusting units will automatically adjust the output volume based upon the ambient noise.
Selectable units allow the end user to change the output level.
Dual Function units have two independently activated tones in one unit.
Star Spectrum units emit a composite buzz tone.
Night Silent feature mutes the sound at night (low light conditions)

US Patent D639,688 S

1. Mount the alarm in the rear of the vehicle with the sound opening

outward towards the hazard zone.

2. For the models with wires, connect the black wire to the negative

side of the battery or a good chassis ground. For the models with
lugs, connect the bottom post (shown to the right) to the negative
side of the battery or a good chassis ground.

3. For the models with wires, connect the red wire to an independent actuating switch or splice it into the

back-up lights as shown in the diagram below. For the lug versions, connect the top post (shown above)
to an independent actuating switch or splice it into the back-up lights. Please Note: The vehicles supply
voltage must be the same as the voltage rating specified on the alarm you are installing. Any other
voltage applied will void the warranty
.

4. For models with a 3-Wire Cable:

• If you ordered a model with a selectable decibel level (66-802S or 66-907S), connect the white wire

with the red wire (BAT +) for the lower dB output, or cut it short and tape it off for the higher dB
output. An optional switch may be installed to allow the driver to select which level the back-up alarm
operates at.

• If you have a dual function model (66-097DF), the white wire is used for an alternate output. Connect

it to the positive side of your power through the switch that controls the alternate function.

• If you have a model with the Night Silent option (NS models), connect the white wire to your parking

light wire, or other switched +12VDC source. The alarm will be de-activated whenever the white wire
has +12VDC applied to it.











































Model #

dB

Current

Voltage

Wires

Single Tone

66-087

87

0.3A

12-36VDC

66-097

97

0.3A

12-36VDC

66-097-12

97

0.3A

12VDC

66-102

102

0.3A

12-36VDC

66-107-12

107

0.7A

12VDC

66-107-24

107

0.3A

24VDC

68-112

112

0.7A

12-24VDC

Dual Tone

66-097DT

97

0.3A

12-36VDC

66-102DT

102

0.7A

12VDC

Auto-Adjusting

66-707A

77-107

0.3A

12-24VDC

66-802A

82-102

0.3A

12-24VDC

66-807A

87-107

0.7A

12VDC

66-807A-24

87-107

0.3A

24VDC

Star Spectrum

66-087SS

87

0.3A

12-36VDC

66-092SS

92

0.3A

12-36VDC

66-097SS

97

0.3A

12-36VDC

Lugs / No Wires

Single Tone

66L-087

87

0.3A

12-36VDC

66L-097

97

0.3A

12-36VDC

66L-097-12

97

0.3A

12VDC

66L-102

102

0.3A

12-36 VDC

66L-107-12

107

0.7A

12 VDC

66L-107-24

107

0.3A

24VDC

68L-112

112

0.7A

12-24VDC

Dual Tone

66L-097DT

97

0.3A

12-36VDC

66L-102DT

102

0.7A

12VDC

Auto-Adjusting

66L-707A

77-97

0.3A

12-24VDC

66L-802A

82-102

0.3A

12-24VDC

66L-807A

87-107

0.7A

12VDC

Cable

Single Tone
/Night Silent

66-087NS

87

0.3A

12-36VDC

66-097NS

97

0.3A

12-36VDC

66-102NS

102

0.3A

12-36VDC

Dual Function

66-097DF

97

0.3A

12-36VDC

Selectable

66-802S

87 or 102

0.3A

12-36VDC

66-907S

97 or 107

0.7A

12VDC

Star Spectrum
/Night Silent

66-087SSNS

87

0.3A

12-36VDC

66-097SSNS

97

0.3A

12-36VDC

Single Tone

68C-112

112

0.7A

24VDC

GOOD

CHASSIS
GROUND

RED

66-802S or 66-907S: OPTIONAL SWITCH FOR OUTPUT SELECTION:

CONNECT THE WHITE WIRE TO +12 VDC FOR LOWER db OUTPUT

or

66-097DF: OPTIONAL SWITCH FOR 2nd DEVICE TO ACTIVATE B-U ALARM:

CONNECT THE WHITE WIRE TO +12 VDC FOR ALTERNATE OUTPUT

or

NS Models: OPTIONAL SWITCH TO DE-ACTIVATE B-U ALARM AT NIGHT:

CONNECT THE WHITE WIRE TO PARKING LIGHTS OR +12 VDC SWITCH

BATTERY

GOOD

CHASSIS
GROUND

The White wire will only be present on models with a selectable

decibel level (66-802S and 66-907S), dual function capability

(66-097DF), or the Night Silent option (NS models).

WHITE

SPLICE THE RED WIRE FROM THE BACK-UP ALARM INTO

THE WIRE WHICH SUPPLIES POWER TO YOUR REVERSE LIGHT

PRE-EXISTING SWITCH IN VEHICLE ALREADY CONNECTED TO
REVERSE LIGHTS (OFTEN ACTIVATED BY THE GEAR SHIFTER)

GOOD

CHASSIS
GROUND

B

L

A

C

K

REVERSE

LIGHT

66/68 Series w/Wires

66L/68L Series w/Lugs

66L/68L Series

ONE YEAR LIMITED WARRANTY

The manufacturer warrants each new product, under normal use, against factory defects in material and
workmanship for one year after the date of purchase. The owner will be responsible for returning to the Service
Center any defective item(s) with the transportation costs prepaid. The manufacturer will, without charge, repair
or replace at its option
, products, or part(s), which its inspection determines to be defective. Repaired or
replacement item(s) will be returned to the purchaser with transportation costs prepaid from the service point. A
copy of the purchaser's receipt must be returned with the defective item(s) in order to qualify for the warranty
coverage.
Exclusions from this warranty include, but are not limited to, bulbs, strobe tubes, domes, and/or the finish. This
warranty shall not apply to any light, which has been altered, such that in the manufacturer's judgment, the
performance or reliability has been affected, or if any damage has resulted from abnormal use or service. This
warranty does not apply to defect or damage occurring as a result of disaster, accident, abuse, misuse,
lightning, power surges, or failure to follow instructions in any enclosed manuals. Any damage or defects
occurring as a result of any unauthorized service or repairs by unauthorized persons shall be excluded from this
warranty.
There are no warranties expressed or implied (including any warranty of merchantability or fitness), which
extend this warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss
or consequential damages, including costs of any labor, are not covered.
The manufacturer reserves the
right to change the design of the product without assuming any obligation to modify any product previously
manufactured.
This warranty gives you specific legal rights. You might also have additional rights which may vary from state to
state. Some states do not allow limitations on how long an implied warranty lasts. Some states do not allow the
exclusion or limitation of incidental or consequential damages. Therefore, the above limitation(s) or exclusion(s)
may not apply to you.

66/68C Series w/Cable

Advertising
This manual is related to the following products: