SurgeX SX-AX20E - Manual (Page 3)

© 2015 SurgeX/Electronic Systems Protection, Inc. | Technical Support: 800-645-9721 | surgex.com | QS-Axess Elite-Rev B 2
Quick Start Guide
III. Line Interface
1.
Command Line Interface (CLI): Many configuration
parameters may be set using the Command Line Interface
(CLI). The CLI is accessed through the network using a
telnet client, or through the serial port.
a. Open a telnet client and point it to the current IP
Address of the Axess Elite.
(Factory Default is DHCP Assigned, telnet Port 23)
b. Connect to the Serial port. (Factory Default is 9600,8,n,1)
c. Upon connection, press Enter, and then enter the
username and password when prompted.
The example shows the basic commands to set the network
parameters. After setting these parameters, the Axess Elite
will need to be rebooted for the settings to take effect. Any
command that requires rebooting of the Axess Elite will
provide a prompt to do so. All commands may be entered as
required before rebooting. Once the IP address is set, the
following command can be used to prevent DHCP from
altering it: set ipmode static
2. Web Page Setup – Manual: From the Device View
page, click Setup, and then Network. Enter the new IP
Address, Subnet Mask, and Gateway, and then click
Save. Click the Reboot button to restart with the new
settings.
3. Web Page Setup – DHCP: From the Device View page, click
Setup, and then Network. Change the IP mode from Static to
DHCP. Click Save, and then Reboot. The Axess Elite will
automatically obtain
its network settings from the DHCP server. Check the server
IP/MAC
table or use the serial CLI to obtain the new settings.