5 device commands, Axess elite user manual – SurgeX SX-AX20E User Manual
Page 23
Axess Elite
User Manual
Firmware Version v1.06.227
© SurgeX | Technical Support: 800-645-9721 | surgex.com
3
6.5
Device Commands
Command
Description
Admi
Fact Def
get all
get outlets get status
Returns the status of all AC outlets and the following system level measurements:
•
Device Name
•
Line Voltage
•
Total Current Draw
•
Total Power Draw
•
Total Energy Used
•
Reboot Time currently in use
•
Delay Time currently in use
•
Temperature
•
On/Off status of each outlet
•
Current draw of each outlet
•
Power Draw of each outlet
No
get outlet <1
‐10>
Returns the status of the specified outlet. AC outlets are numbers 1-8. Aux Relays
A and B are numbers 9 and 10.
No
set outlet <1
‐10> <on/off/reboot>
Sets the selected outlet to the selected state. The user must have rights to
the selected
No
get devicename
Returns the device name.
No Axess ELITE
set devicename <devicename>
Sets the device name.
Yes
get reboot
Returns the Reboot Time.
No
set reboot <1-99>
Sets the Reboot Time in seconds.
No
5
get delay
Returns the Delay Time.
No
set delay <0-99>
Sets the Delay Time in seconds.
No
1
get console
Returns the current console timeout and baud rate.
No
set autologout <0-99>
Sets the automatic logout timeout of web and CLI in minutes. 0 = no timeout.
Yes
2
set baud < 2400 | 9600 | 57600 | 115200 > Sets the serial port baud rate.
Yes
9600
clear shutdown
Clears a persistent shutdown state.
No
set clear shutdown by user < yes | no >
Sets the ability of a user account to clear a persistent shutdown state.
Yes
Y
get upload enable
Returns the status of the ability to accept a firmware upload.
No
set upload enable < yes | no >
Sets the ability to accept a firmware upload.
Yes
Y
clear log
Clears history text log file.
Yes
set factory defaults
Resets all parameters, except Network Settings, to their factory default settings.
Confirmation is required. Note: This command may take up to 30 seconds to execute.
Yes
logout
Ends the session.
No
reboot
Reboots the unit. Will not affect the status of the outlets.
No