Tiptop Access - Manual (Page 4)

ZEUS Access
Installation:
Prior to starting, please view the wiring diagram on the next page to get
an understanding of the entire process.
Push down the lever on the Zeus Studio Bus using a small flat screw driver or
your finger and insert the Green lead to the “GND”, let go of the lever and the
wire will be locked.
Do the same as above, this time insert the Red lead to the “+15V”, let go of the
lever and the wire will be locked.
Make sure both leads are fully inserted into the terminal holes.
Attach the Zeus Studio Bus Board to the case as described in the Zeus Studio Bus
Board manual.
Attach the Zeus Access to the left-most side of your case.
Make sure that both of the leads from the Zeus Access are connected to their
correct spots. RED to +15V, GREEN to GND. Check the illustration below for
reference. NOTE: If the leads are incorrectly installed, you will damage the bus
board!
Connect the Cincon-TTA supply into mains voltage and with the Access’ toggle
switch in the OFF position, plug in the power supply’s barrel connector into the
Access’ DC jack.
While keeping your hand close to the switch, toggle the switch to the ON position
and observe that all three LED’s turned on after 1 second (+5V will turn on first,
+/-12V will turn on after about 1 second NOTE: If one or more LED’s do not light
up upon power up, QUICKLY toggle the switch to the OFF position and double-
check that the wiring scheme outlined earlier is correct.
For more in-depth information on Zeus Studio Bus Board installation
techniques, recommended installation hardware,
guidelines, and dimensions, please refer to the
“Zeus Studio Bus Board” manual.
(Continued)