TracRac IM TracRac Toolbox Mount Kit - Manual (Page 3)

994 Jefferson Street, Fall River, MA 02721
Tel: 800-501-1587, 508-677-4130, Fax: 508-677-4136
(REV B) 06/11/02 Page 3 of 4
7) Flip the box upside down and mark off distance D from the edge of the box’s belly at the front and rear edge of
the toolbox wing. (Figure 3) Repeat for the opposite side. Connect the marks with a straight edge, and scribe a
line. This line is the drilling centerline.
8) You will be drilling the mounting holes on the centerlines from Step 6. Before drilling, double-check your
accuracy by measuring between centerlines. The distance should match Measurement A. (If not, repeat the
process to obtain A, B, and C.)
9) Before drilling the mounting holes, check the inside of your toolbox for the handle locations. If your toolbox’s
handles are on the sides, drill the knob access holes away from handles. The Toolbox Mounts are designed with
an alternate hole for the Knobs. This allows you to move the knob 4” off center to make room for the handles.
10) Drill a ½” diameter hole for the knob at the midpoint (or 4” from the midpoint) of the centerline on the toolbox
wing. Drill two ½” diameter holes along the same line, on each side of the center hole, approx. 6” from
midpoint of the centerline. Repeat for the other side. (Note: Use a 1/8” drill bit for an accurate pilot hole)
11) Slide the Slider Stops onto the inner Top T-Track, one on each side. Slide them to the front, cab-end of the
Base Rails.
Figure 4
12) Slide the Toolbox Mounts onto the inner Top T-Track of each Base Rail, approximately 24”from tailgate.
Starting with the driver’s side, insert the Square Nut into the Slider’s Top Slot, and position it over the selected
hole for the Knob. (see step 8) Thread the 1” Plastic Set Screw through the Nut into the Slider. (Do not bottom
out screw into Base Rail.) Repeat on passenger side. (Figure 4)
SLIDER STOPS
CAB - FRONT
PLASTIC SET SCREW
T-BOLTS
SELF LOCKING NUTS
CENTERLINE Figure 3
D
D