Treasure Garden BASE-AKZ - Manual (Page 2)

Steel
Wrench
Base
Stem
Channels
2 1
Thank you for your purchase of Treasure Garden’s AKZ Cantilever Base.
Please remove all contents from the package, inspect and review parts list.
CAUTION: To reduce personal injury and damage to your base or umbrella, read and
follow this instruction manual. Save information for future reference.
REQUIRED FOR ASSEMBLY:
• 200 lbs. playground sand (not included).
NOTE: Do not put or allow sand into the center of the base shell.
IMPORTANT: Prior to assembly it is important to decide on the location of the AKZ umbrella.
• Allow ample height to avoid damage to your umbrella during assembly and usage.
• Choose a location that is level and sturdy.
• Avoid any sloping or soft ground cover.
• Consider a location that will maximize the umbrella’s rotating swivel function. Placing
the AKZ between two entertaining areas is ideal.
NOTE: Some parts may be included in the styrofoam packaging. DO NOT discard any
packaging or box until assembly is complete.
1 Base Shell 1
2 Base Lid 1
3 Steel Wrench 1
4 Inverted Base Stem 1
5 Inverted Plate 1
6 5mm Hexagon Wrench 1
7 Plate Bolts 4
8 Playground Sand (not included) 200 lbs.
BASE-AKZ PART LIST
Part Description Qty.
Base Assembly
Select area to set AKZ base and place in desired location. NOTE: Moving the umbrella will be
difficult once fully assembled. Remove inverted plate from inverted base stem (Fig. 1).
Remove the inverted base stem by using the steel wrench (provided) turning
counter-clockwise
(Fig. 2), now remove base lid from base shell (Fig. 3). Return
inverted base stem to base shell, to keep sand out of base stem channels. (Fig. 4)
IMPORTANT: Do not allow sand to spill inside the base stem channels, as it will impede
further installation. Now, fill each section of the base shell with dry playground sand (Fig. 5).
Remove inverted base stem (Fig. 6) from base shell. Place base lid back onto base shell and
re-install the inverted base stem (Fig. 7).
IMPORTANT: Carefully, as you tighten the
inverted base stem, you will notice clicking/ratcheting sound. Please make sure it
is between CLICKS. Do not over tighten inverted base stem or parts may be
damaged. Re-install the inverted plate by tightening with 4 plate bolts with supplied 5mm
hexagon wrench (Fig. 8 and 9). Base is now ready for umbrella installation.
(Fig. 1) (Fig. 2) (Fig. 3)
(Fig. 4) (Fig. 5) (Fig. 6)
(Fig. 7)
(Fig. 8) (Fig. 9)