Messaging – Turning Technologies TurningPoint Cloud User Manual
Page 97
TurningPoint Cloud
97
4
Mouse over Participant List and select Real-Time Registration.
The Real-Time Registration Tool opens.
5
Click Play to open registration.
6
Each participant must press a number on their response
device that corresponds with the number to the left of their
name or User ID.
The Device ID for the participant will appear in the Device ID
column.
If more than 10 participants are in the participant list, click
the forward or back buttons to scroll page by page to see the
remaining participants.
7
Click the Pause button to close registration once all
participants have responded.
8
Save the registrations by closing the Real-Time
Registration Tool.
The following message appears.
To permanently save the Device IDs to the participant list, click Yes. Otherwise, click No. If you click No, the software
will not remember Device IDs for future use.
If No is selected, the participant list is temporarily saved. For information on how to save the Device IDs after the
session is completed, see
Saving Device IDs from the Real-Time Registration Tool
WARNING
If the registrations were not saved to the permanent participant list and the session is reset or
polling is closed, the Device IDs are not saved.
Messaging
Participants can send feedback to the instructor by using the Send Message function on the ResponseCard NXT, QT Device
or through the ResponseWare application while polling is open.
IMPORTANT
Compatible receivers for ResponseCard NXT and the Messaging feature are RF 02, 03 and 04.
Compatible receivers for the QT Device and the Messaging feature are RF 03 and 04.
NOTE
ResponseCards RF 02 and 03 can also send feedback, however the ? symbol appears in the Messaging
window instead of a message. To send feedback, participants must press the ? key on their device.
Prerequisites
Prior to viewing the Messaging window, enable the messaging function by clicking the Preferences icon on the TurningPoint
Cloud toolbar. Select Software from the left panel. Check Allow User Messaging below the Administration panel.
turningtechnologies.com/user-guides