Dixon ZTR Classic 13639-0702 - Manual (Page 30)

30
CARE AND MAINTENANCE
CUTTER BLADE MAINTENANCE:
CAUTION Stop engine and remove ignition key for safety.
Wear heavy, thick gloves when holding onto
cutter blade. Avoid the sharp edge of the blade.
Blades should be discarded when worn excessively.
DANGEROUS!
DO NOT USE
BLADE IN
THIS CONDITION!
When notch
starts, discard blade
New Blade
Check sharpness of mower blades after every 10 hours of operation.
Observe proper blade position prior to removal.
1. Safely raise front of mower.
2. Hold or block blade from turning.
3. Loosen blade nut and remove blade.
4. When replacing blade, tighten
blade nut securely. Refer to diagram.
Be sure blade is centered on pilot
before tightening nut to 60 ft. lbs.