Factory default mode – Turning Technologies ResponseCard Programmer User Manual
Page 8
ResponseCard Programmer
8
6
Use the up and down arrows to change the Unit ID. Press Menu/OK.
The following screen appears:
7
Press the designated Program Key on the ResponseCard. For example, if the Program Key is 9/I, press 9/I on the
ResponseCard.
A notification will briefly flash on both the ResponseCard Programmer and the XR-01 or NXT ResponseCard indicating
that the card has been successfully programmed. A green light will flash on the ResponseCard RF indicating that the
card has been successfully programmed.
8
Repeat step 7 until all ResponseCards are programmed.
Factory Default Mode
Factory Default Mode allows users to return ResponseCards back to their original Unit IDs. In this mode, each
ResponseCard Unit ID will be set to the factory Unit ID located on the back of the ResponseCard.
WARNING
If using the ResponseCard XR-01, Factory Default Mode will completely revert the ResponseCard back
to its original state. All stored data will be lost. Turning Technologies is not responsible for any lost data.
1
Press Menu/OK.
2
Use the down arrow to highlight Mode.
3
Press Menu/OK.
4
Highlight Factory Default and press Menu/OK.
5
Highlight Program and select Menu/OK.
The following screen appears:
turningtechnologies.com/user-guides