Ubiquiti Networks airFibe24 - Manual (Page 11)

airFiber Configuration
The instructions in this section explain how to access the airFiber
Configuration Interface and configure the following settings:
•
Wireless Mode Configure one airFiber AF-24 as the Master and
the other as the Slave.
• Duplex The airFiber AF-24 supports both half-duplex and
full-duplex operation. Half-duplex operation provides more
frequency planning options at the cost of higher latency
and throughput. Full-duplex operation provides the highest
throughput and lowest latency; however, you have fewer
frequency management options.
- Half Duplex (default) The TX and RX Frequencies can be the
same or different to suit local interference.
TX
RX
TX
Slave Master
Frequenc
y A
Frequenc
y A
RX
Half-Duplex Diagram
- Full Duplex The TX and RX Frequencies should be different.
TX
RX
TX
RX
Slave Master
Frequenc
y A
Frequenc
y B
Full-Duplex Diagram
• TX and RX Frequencies The TX Frequency on the Master must
match the RX Frequency on the Slave, and vice versa.
9
airFiber Configuration