Ubiquiti Networks PowerBridgM - Manual (Page 5)

Installation Requirements
• 13 mm or ½" wrench
• Flathead screwdriver
• Shielded Category 5 (or above) cabling should be used for
all wired Ethernet connections and should be grounded
through the AC ground of the PoE.
We recommend that you protect your networks from the
most brutal environments and devastating ESD attacks
with industrial-grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable
Hardware Installation
To install the PowerBridgeM, perform the following steps:
1. The Port Cover is hinged to the PowerBridgeM and locked
with a screw. Use a flathead screwdriver to turn the locking
screw counter-clockwise until it is loose. Open the cover by
sliding it down and raising it up.